Annotation: The paper presents the experiment-calculated data on hydraulic parameters of ring intake device in different operation modes. The method of their calculation is proposed taking into account limit deviations of influencing factors. Satisfactory convergence of calculated and experiment data is shown.

Annotation: When accomplishing the task of spacecraft orbital injection, the necessity arises of main engine multiple ignitions and consequently, long pauses between the ignitions are possible. As the propellant during pauses between ignitions is in the conditions of practically full absence of gravitation and can freely move over entire tank volume taking practically any spatial position, to ensure main engine guaranteed ignition the necessity arises to move the propellant into pre-start position. The propellant is moved to the supply lines by way of creating longitudinal acceleration which is done using inertial continuity ensuring means (thrusters). The time of full liquid displacement from one position into another is the most important parameter having an impact on propellant amount in the tanks and accordingly, on power characteristics of a stage. The theoretical calculations of hydrodynamic processes are connected with considerable mathematical difficulties caused by complexity of solving hydrodynamic problems of determination of liquid flowing with free surface taking into account surface tension of the liquid and many other geometrical, kinematic, and dynamic factors. Therefore, the most reliable data from solving these problems are currently obtained only on model hydrodynamic stands where it is possible to model liquid behavior in tanks in the conditions of variable gravitation. The paper presents the authors-developed procedure of calculating the full time required for propellant components deposition during rocket’s apogee stage flight and the procedure of selecting the modeling parameters (scale, time, and acсeleration) to ensure development testing in the conditions of limited test stand base. The use of the proposed procedure allows (in initial phase of launch vehicle development) determining the full time required to perform deposition with sufficient accuracy and thus optimizing the propellant mass required for operation of inertial continuity ensuring system, which in its turn, will allow increasing the payload mass to be injected.